How to control DC motor with L298N driver and Arduino

In this video, I want to show you how to control DC motor with L298N driver
and programming with Arduino and control DC motor with L298N driver by Analog Joystick
Round left and right round – Change speed – Increase and decrease speed
How to control DC motor with L298N driver and Arduino – Analog Joystick – L298
Components required:
1. Arduino UNO
2. breadboard
3. Analog Joystick
4. motor gearbox
5. push button
6. L298N
7. resistor 10 KΩ
Download Codes and Circuit Diagrams
https://www.facebook.com/zin.techideas.3
https://www.instagram.com/zintechideas/
https://twitter.com/Zintechideas
Simple Arduino programming (Turn the LED on and off -Delay in the program)
Arduino programming using the for loop and if else if loop and while loop (LED Flasher)
How to make handmade LED (Low consumption, low cost)💡💡
DIY Short Circuit (Overcurrent) Protection (Save your battery/power supply)
Mini Amplifier Circuit- Powerful 100 Watt DC 12v
How to make led Chaser Without IC – With Transistor BC 547 and resistor
Note: Some People copy my content as well as the thumbnail. I have no issues with content as long they make it themselves. But for the thumbnail, It belongs to respective owners (Some also created by myself). If you get a copyright strike without any notice by copying my thumbnail, it is not my fault. Happy Creating 🙂
WARNING: This video is for demonstration and education purposes only Each demonstration presents risks and hazards that must be fully understood before attempting and should be performed only by professionals
#L298 #drivermotor #motordriver