Arduino programming using Photocell

Arduino programming using Photocell

Hello friends, in this video we want to teach you how to program Photocell and turn the lamp on and off with Arduino

Arduino programming using Photocell – LDR turning the lamp on and off with Photocell

Components required:

1. Arduino UNO

2. breadboard

3. photocell

4. resistor 220Ω

5. resistor 10KΩ

6. LED red

Download Codes and Circuit Diagrams

Simple Arduino programming (Turn the LED on and off -Delay in the program)

Arduino programming using the for loop and if else if loop and while loop (LED Flasher)

How to make handmade LED (Low consumption, low cost)💡💡

Single Key light (on/off)

DIY Short Circuit (Overcurrent) Protection (Save your battery/power supply)

Mini Amplifier Circuit- Powerful 100 Watt DC 12v

How to make led Chaser Without IC – With Transistor BC 547 and resistor

Note: Some People copy my content as well as the thumbnail. I have no issues with content as long they make it themselves. But for the thumbnail, It belongs to respective owners (Some also created by myself). If you get a copyright strike without any notice by copying my thumbnail, it is not my fault. Happy Creating 🙂

WARNING: This video is for demonstration and education purpose only Each demonstration presents risk and hazards that must be fully understood before attempting and should be performed only by professionals

how,how to,how to make,electronic,technical new ideas,arduino,zintechideas,diy,life hack,Arduino UNO,resistor,LDR,portugal vs irelandhotoceel,programming,Arduino programming using Photocell,Simple run Photocell,Simple programming Photocell,Simple run Photocell and led,اموزش برنامه نویسی,اموزش فوتوسل,فوتوسل,turning the lamp on and off,اردوینو,آردوینو,photocellule,ضوئية,фотоэлемент,光电池,célula fotoeléctrica,fotocell,آردوینو چیست,اموزش ساخت فوتوسل,Photoresistor,ldr

مطالب مرتبط

دیدگاهتان را بنویسید

نشانی ایمیل شما منتشر نخواهد شد.